aus
Troubleshooting
56
Fault
Cause and troubleshooting
Programme starts
automatically.
You did not wait until programme ended.
▶
"Terminate programme", Page 36
Appliance stops dur-
ing the programme or
cuts out.
Appliance door is not closed properly.
▶
Close the appliance door.
Power and/or water supply has been interrupted.
1.
Check the power supply.
2.
Check the water supply.
Top basket is pressing against inner door and pre-
venting appliance door from being closed securely.
▶
Check whether the rear panel of the appliance is
being pressed in by a socket or hose holder that
has not been removed.
▶
Arrange the tableware so that no parts project bey-
ond the basket and prevent the appliance door
from closing properly.
All LEDs lit up or
flashing.
Electronics have detected a fault.
1.
Press the main switch button for approx.
4 seconds.
→
The appliance is reset and restarted.
2.
If the problem occurs again:
‒
Switch off the appliance.
‒
Pull out the mains plug or switch off the fuse in
the fuse box.
‒
Wait at least 2 minutes.
‒
Switch on the fuse in the fuse box or insert the
mains plug.
‒
Switch the appliance on.
3.
If the problem occurs again:
‒
Contact customer service.
→
Fault
Cause and troubleshooting
Appliance door can-
not be closed.
Door lock has been activated.
▶
Close the appliance door with greater force.
Door cannot be closed due to installation method.
▶
Check whether the appliance has been installed
properly.
When closed, the appliance door, its decor or at-
tached parts should not knock against adjacent
cabinets or the worktop.
Summary of Contents for SMS8ZDI01A
Page 63: ......
