Troubleshooting
aus
49
Fault
Cause and troubleshooting
Tableware is not dry.
▶
Position tableware at an angle where possible.
The combined detergent used has a poor drying per-
formance.
1.
Use rinse aid to improve drying performance.
2.
Use a different combined detergent with a better
drying performance.
Extra Dry not activated to improve drying perform-
ance.
▶
Activate Extra Dry.
Tableware removed too early or drying process not
yet ended.
1.
Wait until the programme ends.
2.
Only remove tableware 30 minutes after the pro-
gramme has ended.
Rinse aid used has a limited drying performance.
▶
Use a name-brand rinse aid.
Eco products may have limited effectiveness.
Plastic tableware is
not dry.
Not a fault. As plastic does not store heat so well, it
also does not dry as well.
▶
No remedial action possible.
Cutlery is not dry.
Cutlery not arranged properly in the cutlery basket or
cutlery drawer.
Droplets can form on the cutlery contact points.
1.
Arrange cutlery individually where possible.
→
2.
Avoid points of contact.
Appliance interior still
wet after wash cycle.
Not a fault. The condensation drying principle causes
water droplets in the tub – they are indeed desirable
here. The moisture in the air condenses on the inside
walls, runs off and is pumped out.
No action required.
Summary of Contents for SMS8ZDI01A
Page 63: ......
