Troubleshooting
en
39
Fault
Cause and troubleshooting
Wipeable or water-sol-
uble coatings are
present inside the ap-
pliance or on the
door.
2.
Change your detergent if required.
Special salt dispenser is not screwed tight.
▶
Screw the special salt dispenser tight.
Stubborn white coat-
ings are present on
tableware, inside the
appliance or the door.
Detergent substances are deposited there. These
coatings cannot generally be removed with chemicals.
▶
Change your detergent →
.
▶
Clean the appliance mechanically.
The hardness range is set incorrectly or the water
hardness is greater than 44 °E (6,2 mmol/l).
▶
Set the Water softening system →
to the
water hardness or add special salt.
3in1/organic/eco detergent is not effective enough.
▶
Set the Water softening system →
to the
water hardness and use separate detergents (pro-
prietary detergent, special salt, rinse aid).
Too little detergent is being used.
▶
Increase the amount of detergent used or change
Detergent →
Washing programme selected too weak.
▶
Select a more intensive washing programme.
Tea residue or lipstick
marks on tableware.
Washing temperature is too low.
▶
Select a programme with a higher washing temper-
ature.
Too little detergent is being used or is unsuitable.
▶
Use a suitable Detergent →
manufacturer's instructions for the amount to be
used.
Tableware has been precleaned too intensely. The
sensors chose a weaker programme. Stubborn soiling
cannot be entirely removed.
▶
Only remove large remnants of food and do not
prerinse tableware.
