Bosch SHX4AT5, Use And Care Manua

Page: 18 / 56

16
Interrupt a cycle
1 Open the door, press the [On/Off] button to turn the unit off.
2 To resume the cycle, press the [On/Off] button again and close the door.
Cycle Completion Signal
1 Open the door and press the [On/Off] button.
2 Hold down the “ A ” button (see page 15) and press [Start] until the
display indicates “ d:00 ”. Release both buttons.
3 Press the “ A ” button until the display shows “ b:02 ”.
4 Press the “ C ” button to increase or decrease the tone “ b:00 ” = OFF
and “ b:03 ” = LOUDEST
5 Press [Start] to save setting and close the door.
Delay Start
You can delay the start of the cycle in one hour increments up to 24 hours.
1
Open the door and press the [On/Off] button and select desired cycle.
2 Press the [Delay] button until the displayed time corresponds with
your requirements.
h:01 = 1 hour delay h:24 = 24 hour delay
3 Press [Start] to activate delay start. Wash cycle will begin after set time.
To cancel delay start:
1
Press the [Delay] button until “ h:00 ” is indicated on the digital display.
2 Press [Start] to save setting and close the door.
Intensive Drying
The final rinse uses a higher temperature which improves the drying
results. The running time may increase slightly.
To turn intensive drying on:
1
Open the door and press the [On/Off] button.
2 Hold down the “ A ” button (see page 15) and press [Start] until the
display indicates “
d:00
”. Release both buttons.
3 Press the “ C ” button to turn intensive drying on or off. “ d:01 ” = ON
and “ d:00 ” = OFF
4 Press [Start] to save setting and close the door.
InfoLight®
An LED illuminates the floor to indicate the unit is running. If the appli-
ance is installed at eye-level, the LED is not visible.
To change the setting:
1
Open the door and press the [On/Off] button.
2 Hold down the “ A ” button and press [Start] until the display indi-
cates “ d:00 ”. Release both buttons.
3 Press the “ A ” button until the display shows “ 1:01 ”.
4 Press the “ C ” button to switch between “ 1:01 ” = ON and “ 1:00 ” =
OFF and press [Start] to save. Close the door.