Bosch SHX4AT5, Use And Care Manua

Page: 14 / 56

12
Rinse Aid
To achieve proper drying, always use a liquid rinse aid, even if your
detergent contains a rinse aid or drying additive.
Note: The dishwasher indicates low rinse aid by turning on the “Add Rinse
Aid” indicator light. If this light is on, you need to refill the rinse aid dis-
penser by following the directions below.
Adding Rinse Aid
1 Add liquid rinse aid to the dispenser until
it is full (see
Figure 7 ).
2 Close the lid. Lid must be fully closed
until it clicks in order to seal.
3 Wipe up any excess rinse aid that may have
puddled when the dispenser reservoir is full.
The indicator light will go out a few moments after the
dishwasher door is shut. See next page for instruction
on how to adjust the amount of rinse aid dispensed.
Setting the amount of rinse aid used
The amount of rinse aid dispensed can be set from “r:00” to “r:06”.
1
Press the [On/Off] button.
2 Hold down the “ A ” button (see page 15) and press [Start] until
the display indicates “ d:00 ”. Release both buttons.
3 Press the “ A ” button until the display shows “ r:05 ”.
4 Press the “ C ” button to select the desired setting.
“ r:00 ” = dispenser is OFF
“ r:01 ” = lowest setting
“ r:02 ” = low setting
“ r:03 ” = medium setting
5 Press [Start] to save the setting.
Note: Using rinse aid and setting the dispenser to “r:00” may result in lon-
ger cycle times
.
Table 1 - Recommended Detergent Amount
Wash Cycle
Hard Water/
Heavy Soil
Medium Water/
Medium Soil
Soft Water/
Little Soil
Heavy 45ml (3tbsp) 45ml (3tbsp) 25-45ml (1.75-3tbsp)
Auto 25-45ml (1.75-3tbsp) 25ml (1.75tbsp) 15-25ml (1-1.75tbsp)
Normal 25-45ml (1.75-3tbsp) 25ml (1.75tbsp) 15-25ml (1-1.75tbsp)
Speed60™ 25ml (1.75tbsp) 15-25ml (1-1.75tbsp) 15ml (1tbsp)
Rinse None None None
Figure 7
“ r:04 ” = medium/high setting
“ r:05 ” = high setting
“ r:06 ” = highest setting