Bosch SGE63E15UC, Operating Instructions Manual

Page: 15 / 64

13
Operating the Dishwasher
NOTE: The SHE9ER55UC models have hidden controls, therefore, the door must be opened before chang-
ing settings and closed after changing settings.
Start the dishwasher
1
Press the [On/Off] button. The LED of the last selected cycle flashes.
2
Select a cycle and desired options.
3
Press [Start] .
Cancel a cycle
1
Press and hold the [Start] button for approximately 3 seconds until the display reads “0:01”.
2
Wait about 1 minute while the dishwasher drains.
3
Open the door and press the [On/Off] button.
Interrupt a cycle
1
Press the [On/Off] button to turn the unit off.
2
To resume the cycle, press the
On/Off
button again.
Setting the amount of rinse aid
The amount of rinse aid dispensed can be set from “r:00” to “r:06”.
To change the setting:
1
Press the [On/Off] button.
2
Hold down the “ A ” button (see page 4) and press [Start] until the display indicates “ H:00 ”.
3
Release both buttons.
4
Press the “ A ” button until the display shows “ r:05 ”.
5
Press the “ C ” button to select the desired setting.
“ r:00 ” = dispenser is OFF
“ r:01 ” = lowest setting
“ r:02 ” = low setting
“ r:03 ” = medium setting
“ r:04 ” = medium/high setting
“ r:05 ” = high setting
“ r:06 ” = highest setting
6
Press [Start] to save the setting.
Delay Start
You can delay the start of the cycle in one hour increments up to 24 hours.
To set delay start:
1
Press the [On/Off] button.
2
Press the [+] button until the display jumps to “ h:01 ”.
3
Press the [+] or [-] button until the displayed time corresponds with your requirements.
h:01 = 1 hour delay
h:24 = 24 hour delay
4
Press [Start] to activate delay start.
To cancel delay start:
1
Press the [+] or [-] button until “ h:00 ” is indicated on the digital display.
2
Press [Start] to save setting.
Cycle Completion Signal (SHE9ER55UC only)
1
Open the door and press the [On/Off] button.
2
Hold down the “ A ” button (see page 4) and press [Start] until the display indicates “ H:00 ”.
3
Release both buttons.
4
Press the “ A ” button until the display shows “ b:02 ”.
5
Press the “ C ” button to increase or decrease the tone “ b:00 ” = OFF and “ b:03 ” = LOUDEST
6
Press [Start] to save setting and close the door.