Bosch sensixx B10L Series, Operating Instructions Manual

Page: 14 / 132

14
B O S C H
EN
G
lI
SH
• This appliance is to be connected and used
in accordance with the information stated on
its characteristics plate.
• This appliance must be connected to an
earthed socket. If it is absolutely necessary
to use an extension cable, make sure that it
is suitable for 16A and has a socket with an
earth connection.
• If the safety fuse itted in the appliance
blows, the appliance will be rendered
inoperative. To restore normal operation
the appliance will have to be taken to an
authorised Technical Service Centre.
• In order to avoid that, under unfavourable
mains conditions, phenomena like transient
voltage drops or lighting luctuations can
happen, it is recommended that the iron
is connected to a power supply system
with a maximum impedance of 0.27 Ω .
If necessary, the user can ask the public
power supply company for the system
impedance at the interface point.
• The appliance must never be placed directly
under the tap to ill the water tank.
•
Unplug the appliance from the mains supply
after each use, or if a fault is suspected.
• The electrical plug must not be removed
from the socket by pulling the cable.
• Never immerse the iron or steam tank in
water or any other luid.
• Do not leave the appliance exposed to
weather conditions (rain, sun, frost, etc.).
Important :
• This appliance reaches high temperatures
and produces steam during use, this could
cause scalds or burns in case of improper
use.
• The steam hose, base station, metal plate
at the bottom of the removable iron pad (2)
and in particular the iron can get hot when
used. This is normal.
• Do not allow the power cable to come into
contact with the soleplate when it is hot.
• Never aim the steam at people or animals.
Description
1. Boiler´s cap
2. Removable iron pad
3. Mains cable and hose storage compartment
4. Mains cable
5. Steam hose
6. “Steam ready” pilot light
7. “Reill boiler” pilot light
8. Variable steam control *
9. Illuminated main power button (0/I)
10. Housing with internal steam generator
11. Temperature control knob
12. Steam release button
13. Iron pilot light
14. Soleplate
15. Steam button lock *
16. Filling funnel
17. Carrying handles
* Model dependent
a
preparations
1. Remove any label or protective covering
from the soleplate.
2. Place the appliance horizontally on a solid,
stable surface. You may remove the iron
pad (2) from the appliance and place the
iron on it on another solid, stable, horizontal
surface. Never rest the iron on the
appliance without the iron pad!
3. Open the boiler´s cap (1). Fill the boiler
carefully using always the funnel , and
close the cap irmly.
Filling with warm water reduces the waiting
time for heating up.
Do not overill the boiler.
4. Unwind the mains cable (4) fully and plug it
into an earthed socket.
5. Switch the main power button (9) on (position “I”)
6. The “Steam ready” indicator lamp (6) will
light up after approximately 7 minutes,
indicating that the appliance is ready to use.
7. This appliance has a water level sensor.
The “Reill boiler” indicator (7) will light when
the boiler is empty.