High Density Video Cassette Recorder |
Instruction Manual
|
Installation
Bosch Security Systems | 26 Feb 2003 | Draft
EN
| 12
5.5
Video Cassette Tapes
This VCR will operate with any video cassette which
has the VHS mark.
When handling video cassette tapes:
• Do not expose video cassettes to extreme heat, high
humidity, or strong magnetic fields.
• Do not tamper with the cassette mechanism.
• Do not touch the tape with your fingers.
• Always store an unused cassette in its case.
Loading:
Hold the cassette with the
arrow side up (top). Insert
the cassette gently into the
slot in the direction of the
arrow (on the cassette) until
the loading mechanism
automatically pulls the
cassette into the unit. Make
certain that the cassette is
inserted correctly.
If the cassette is not loaded correctly, the VCR will
eject the cassette automatically after approximately 3
seconds.
Unloading:
Press the STOP/EJECT
button twice. The cassette
will be ejected
automatically. After the
cassette is visible in the tape
slot, pull it out to remove it.
Unloading the cassette is
possible only when the
power cord is connected to
the wall outlet.
The cassette can be ejected when the STOP/EJECT
button is pressed, even if the VCR’s power is OFF.
Video cassette safety tab:
To prevent accidental erasure
of recorded material, remove
the safety tab from the lower
left corner of the cassette.
Recording is impossible when
the safety tab is removed.
Your VCR will automatically eject it if you attempt to
record on it.
5.6
Normal Playback
Turn on the power of both the VCR and the
MONITOR.
1. Insert a prerecorded video cassette.
The indicator will light and the VCR will power-
up automatically.
If a tape without a record protect tab is inserted,
the unit will start the playback automatically
2. Press the PLAY button.
Press - or + button to choose the desired
time mode, 6H, 18H, 30H etc.
The selecting time is displayed in the VCR
indicator panel.
If the tape reaches the end before STOP is pressed,
the VCR will automatically stop and rewind.
3. Press the STOP button to stop playback.
Note:
• If during playback the STILL button is pressed,
then after 5 minutes in this mode, the playback will
automatically go into standby mode to protect the
tape and video heads.
Tracking Adjustment:
If noise appears on the screen during
playback, press either MOVE (TRACKING)
or SELECT (TRACKING) buttons until the noise on
the screen is reduced. In case of vertical jitter, adjust
these controls very carefully (adjustment during STILL
mode). Tracking is automatically reset to normal when
the tape is ejected.
