15/
28
Bosch Rexroth AG
VT-MSFA1 | RE 30260-B/07.12
Transport and storage
6 Transport and storage
There are no special transport instructions for this product. You must, however,
observe the notes in chapter 2 "General safety instructions" and comply with the
environmental conditions for storage and transport which are detailed in the tech-
nical data of data sheet 30260.
6.1 Storing the VT-MSFA1
Proceed as follows in order to prepare the VT-MSFA1 booster amplifier for stor-
age and further use:
f
Only use the original packaging for storage.
f
Comply with the admissible storage temperature range (see RE 30260).
f
Protect the VT-MSFA1 from dust and humidity.
7 Assembly
wARnInG
Pressure equipment or device parts flying around!
Risk of injury caused by parts flying around or oil jet spurting out if hydraulic
parts or hydraulic lines have not been correctly or completely assembled before
application of the pressure
f
Depressurize the relevant part of the system before the assembly.
f
Use sufficiently dimensioned connection threads with sealing points.
f
Have the assembly performed by an expert according to these instructions
and check the system before commissioning with corresponding overpres-
sure according to ISO 4413.
CAUTIOn
Fault currents and short-circuits!
Impairment of safety and malfunctions.
f
The environment must be free from electrically conductive contamination
(acids, bases, corrosive agents, salts, metal vapors, etc.) and the device
must not be exposed to these substances. Rule out any deposits according
to protection class IP 20.
Cables lying around!
Risk of stumbling!
f
Lay the cables and lines so that they cannot be damaged and no one can trip
over them.
