6. Open the housing cover. One or two hard disks are located in the middle of the
inner side of the device door, see
fig. 14-3 "Position of the hard disk and of the
fastening screws (inside)" on page 34
.
①
Hard disk
②
Hard disk screws
③
Housing fan
Fig.14-2: Position of the hard disk and of the fastening screws (inside)
7. Remove the connecting cables of the hard disk.
8. Remove the fastening screws of the hard disk. After mounting, the four fastening
screws for the hard disks are located either on the rear side of the device door or
on the fastening screw holders.
9. Exchange the old hard disk for a new hard disk.
10. Fix the new hard disk according to the mounting location using screws.
Observe the different screw lengths for the outer (8 mm) and inner (6 mm)
fastening screws of the hard disk.
Bosch Rexroth AG
Maintenance
DOK-SUPPL*-VSP*XX.3***-IT01-EN-P
Rexroth IndraControl VSP xx.3 Panel PC
34/43
