1
①
Release lever
Fig.10-19:
Position of the release lever
2.
Tilt the control upwards (C in
Fig.10-20:
Dismounting the control from the top-hat rail
3.
Remove the control by pulling it diagonally upwards (C in
).
10.6
Dismounting and changing the Inline terminals
Removing an Inline terminal
1.
Remove the labeling field, if present (A1 in
).
Remove all connectors of the terminal. The sections below de‐
scribe how to remove a 2-slot terminal.
2.
Pry out the connector of the terminal to be removed by pressing on the
rear connector shaft latch (A2 in
).
Bosch Rexroth AG
DOK-CONTRL-IC*LX5*****-IT01-EN-P
Rexroth IndraControl L25, L45, L65 and L85 Controls
36/65
Mounting, Dismounting and Electrical Installation
