Bosch Rexroth GTM Series, Project Planning Manual

Page: 67 / 90

Planetary Gearboxes Assembly
10-3
DOK-GEAR**-GTM********-PR01-EN-P
10.2.2 Mounting procedure
The following assembly procedure is recommended:
1. Clean and check the parts. Check for damage to the motor shaft,
compression coupling bore and any bushing, as well as the faces of
motor and gearbox flanges and clean them thoroughly. Do not clean
the parts with compressed air. Avoid using aggressive detergents
which could damage the seals.
GG000003v01_en.EPS
Fig. 10-2: Cleaning of the parts before mounting
2. Remove cap screws. Remove the cap screws from the gearbox
adapter plate. The removal will allow access to the two screws in the
compression coupling. Turn the compression coupling so that the
heads of the clamping screws line up with the tapped holes which
have now been opened in the gearbox´s adapter plate.
GG000004v01_en.EPS
Fig. 10-3: Remove the cap screws