18
en | Enrollment
RADION Life Safety
2020.06 | 03 | F.01U.361.555
Installation manual
Bosch Security Systems, B.V.
7
Enrollment
7.1
Programming wireless points in the control panel
Configure the RADION points to establish communication between the RADION system and
the control panel. This can be accomplished by using one of two methods:
–
Using Remote Programming Software (RPS) on a supported laptop computer, or
–
Compatible keypad devices to enable your points
A “point” can be a detection device, or a group of devices connected to your security system.
The first step to enable communication is to verify that the RADION transmitter is
programmed into the control panel. This is achieved by configuring a point source index as
wireless.
RFID programming from a supported keypad is achieved by:
–
Through the point source/RFID menu options, or
–
Enroll point RFID for wireless points - which uses the “Auto-Learn” methodology.
The preferred method of entering in the RFID number would be to enter it in manually through
the keypad - point source/RFID, or RPS. Doing so gives you greater control and security, while
reducing the risk of incomplete RFID programming.
The workflow listed below is a generic representation of the programming/enablement
process. Refer to the Points Menu Parameters section inside the Keypad Installer Menu
chapter of the compatible Bosch control panel Installation and System Reference Guides, or
Points - Point Assignments in RPS Help File for more information.
Point source/RFID programming
A point’s source gives a description as to the physical location of the point for installation and
service personnel:
1.
Using either RPS, or a supported keypad, access the Program Menu, and select the
Points
menu option.
2.
Select the
Source
menu.
3.
Select the point source of the device you are programming.
4.
Change the point source to the “wireless."
5.
Save changes.
6.
Select the
RFID
menu
to edit the RFID of each RADION device.
7.
Enter in the unique RFID as it appears on the RFID sticker in the illustration below. ID’s
beginning with a zero may not display in the keypad UI, or RPS
8.
Save changes and exit the menu.
The control panel is enabled to receive wireless communication information from the RADION
transmitter.
