English |
17
Bosch Power Tools
1 609 92A 1G4 | (15.10.15)
Selecting the Application Tool/Accessory
The following table shows examples for application tools. Further application tools can be found in the extensive Bosch acces-
sories program.
Accessory
Material
Application
BIM segment saw
blade
Wooden materials,
Plastic,
Non-ferrous metals
Separating and plunge cuts; also for sawing close to edges,
in corners and hard to reach areas;
example: shortening already installed bottom rails or door
hinges, plunge cuts for adjusting floor panels
Base plate for sand-
ing, series Delta
93 mm
Depends on sanding sheet Sanding surfaces close to edges, in corners or hard to reach
areas;
depending on the sanding sheet for, e.g., sanding wood,
paint, varnish, stone
Fleeces for cleaning and for texturing wood, removing rust
from metal and for keying varnishes, polishing felt for pre-
polishing
Profile sander
Wood,
Pipes/Profile,
Paint,
Varnishes,
Filler,
Metal
Convenient, efficient sanding of profiles up to a diameter of
55 mm;
Red sanding sheets for sanding wood, pipes/profiles,
varnishes, fillers and metal
BIM plunge cut saw
blade, wood and
metal
Softwood,
Soft plastics,
Plasterboard,
Thin-walled aluminium
and non-ferrous metal
profiles,
Thin sheet metals,
Non-hardened nails and
screws
Smaller separating and plunge cuts;
example: cutting an opening for sockets, flush cutting a
copper pipe, plunge cuts in plasterboard
Filigree adjustment work in wood;
example: sawing openings for locks and fittings
HCS plunge cut saw
blade, wood
Wooden materials,
Soft plastics
Separating and deep plunge cuts; also for sawing close to
edges, in corners and hard to reach areas;
example: narrow plunge cut in solid wood for installing a
ventilation grid
Bi-metal plunge
cut saw blade,
hardwood
Hardwood,
Laminated panels
Plunge cuts in laminated panels or hardwood;
example: installing skylights
TC plunge cut saw
blade, metal
Metal,
Severely abrasive
materials,
Fibreglass,
Plasterboard,
Cement-bonded fibre
boards
Plunge cuts in severely abrasive materials or metal;
example: cutting kitchen front covers, easy cutting through
hardened screws, nails and stainless steel
BIM plunge cut saw
blade, wood and
metal
Softwood,
Hardwood,
Veneered panels,
Plastic-laminated panels,
Non-hardened nails and
screws
Plunge cuts in laminated panels or hardwood;
example: shortening door frames, cutting openings for a
shelf
HM-Riff segment
saw blade
Cement joints,
Soft wall tiles,
Glass fibre reinforced
plastics,
Porous concrete
Cutting and separating close to edges, in corners or hard to
reach areas;
example: removing grouting joints between wall tiles for
repair work, cutting openings in tiles, gypsum boards or
plastic
OBJ_BUCH-2653-001.book Page 17 Thursday, October 15, 2015 4:27 PM
