English 6
4. Place a wood block on the underside of the cabinet where the adjusting screw
will meet the countertop. The adjusting screws will tighten down on the wood
block to clamp the cooktop tightly to the countertop. This will protect the coun-
tertop surface from damage.
5. Rotate brackets into proper position and insert clamping screws into the
brackets.
6. Tighten clamping screws into wood blocks to secure cooktop to countertop.
5) Trim Excess Aluminum Tape
(solid surface countertop
installation only)
Trim excess aluminum tape from along the frame edges. BE CAREFUL not to
scratch the countertop.
6) Electrical Connection
1. Attach flexible conduit to the junction box.
2. Connect the cooktop lead wires to the junction box supply wires in proper
phase: for all models, connect black (L1) to black, red (L2) to red, white wire
to neutral, green wire to ground.
Note: The ground wire and neutral wire are twisted together at the factory. For
proper operation, untwist and connect to the required four wire system.
NOTE:
If the cooktop is installed and connected as specified above, it will be com-
pletely grounded in compliance with the National Electrical Code.
7) Final
Check
1. Remove everything from the cooktop surface and apply glass ceramic cook-
top cleaner (packaged with cooktop) as directed in Use and Care Manual.
2. Turn on power supply.
3. Test operation.
CAUTION
:
Your cooktop surface needs to be cleaned daily. Refer
to the Use and Care Manual before using it for the first time.
Figure 6:
Secure the Cooktop
washer
threaded
screw hole
burner box
burner box
bracket
bracket
clamping screw
screw
wood block
countertop
