Bosch MUZS24DSW, User Manual

Page: 19 / 144

Before using the appliance
en
19
4.4 Overload protection
The overload protection system pre-
vents the motor and other compon-
ents from being damaged through
being overloaded.
If the continuous feed shredder is
overloaded or blocked, the disc
holder shaft will break at the prede-
termined breaking point.
Note:
Spare parts with a predeter-
mined breaking point are not covered
by our warranty obligations. A new
disc holder is available from cus-
tomer service under order number
00630760.
Before using the appliance
5 Before using the appli-
ance
Before using the appliance
Prepare the base unit and the ac-
cessories for use.
5.1 Overview of base units
You can prepare your kitchen ma-
chine as shown.
→ Fig.
3
A
Food processor from the
MUM5 series
B
Food processor from the
MUMS2 series
5.2 Assembling the continu-
ous feed shredder
1.
Grip the disc holder level with the
wings.
→ Fig.
4
The two plastic tips must point up.
2.
Take hold of the required cutting
disc by the edge and fit onto the
disc holder with the side you re-
quire facing up.
‒
Fit single-sided discs with the
blades or serrations facing up.
‒
Fit reversible discs with the re-
quired marking facing up.
→ Fig.
5
3.
Insert the disc holder with the cut-
ting disc into the housing.
→ Fig.
6
4.
Place the lid on the housing.
→ Fig.
7
Markings and must match
up.
5.
Rotate the lid clockwise until it en-
gages.
→ Fig.
8
Markings and must match
up.
5.3 Fitting continuous feed
shredder onto the base
unit
1.
Place the continuous feed shred-
der on drive 2 as shown.
→ Fig.
9
2.
Push the continuous feed shredder
down and rotate clockwise until it
engages.
→ Fig.
10
The continuous feed shredder
must be securely connected to the
base unit.
Basic operation
6 Basic operation
Basic operation
6.1 Processing food with the
continuous feed shredder
Note:
Take note of the recommended
speeds.
→
"Application examples", Page 21