27
en
Bowl and tools
■
Insert the bowl:
Tilt the bowl forwards and then set it
down. Turn anti-clockwise until it locks
into place.
■
Press the Release button and
move the swivel arm to
position
3
.
■
Remove drive cover from the
drive of the continuous-feed shredder
(Fig.
G
-5a)
.
■
Hold disc holder at the lower end,
ensuring that the two tips are face up.
■
Carefully place the required slicing
or shredding disc onto the tips of the
disc holder
(Fig.
G
-6a)
. In the case
of reversible discs, ensure that the
required side is face up.
■
Grip disc holder at the upper end and
insert into the housing
(Fig.
G
-6b)
.
■
Attach the cover (note mark) and turn all
the way in a clockwise direction.
■
Place continuous-feed shredder on the
drive and rotate all the way in a clock-
wise direction, as illustrated in
Fig.
G
-8
.
■
Turn rotary switch to recommended
setting.
■
Put food to be processed in the feed
tube and push down with the pusher.
W
Warning!
Prevent the cut ingredients from building up
in the outlet opening.
Tip:
To ensure even cutting results, process
thin ingredients in bunches.
Note:
If the food to be processed sticks in
the continuous-feed shredder, switch food
processor off, pull out mains plug, wait until
the drive comes to a standstill, remove
cover from the continuous-feed shredder
and empty feed tube.
After using the appliance
■
Switch off the appliance with the rotary
switch.
■
Rotate the continuous-feed shredder in
an anti-clockwise direction and remove.
■
Rotate the lid in an anti-clockwise
direction and remove.
■
Remove disc holder with disc. To do
this, press finger from below against the
drive shaft
(Fig.
H
)
.
■
Clean parts.
Blender
Observe the application examples in
table
O
W
Risk of injury from sharp blades /
rotating drive!
Never place fingers in the attached blender!
Do not remove / attach the blender until the
drive is at a standstill! Operate the assem-
bled blender only and with the lid attached.
Do not operate blender when empty.
W
Risk of scalding!
If processing hot liquids, steam escapes
through the funnel in the lid.
Working with the blender
Figure
J
:
■
Press the release button and
move the swivel arm to
position
4
.
■
Remove the blender drive cover.
■
Attach blender jug (mark on the handle
on mark on the base unit) and turn all
the way in an anti-clockwise direction.
■
Add ingredients.
Maximum capacity – liquid = 1.25 litres;
maximum capacity frothing or hot liquids
max. 0.75 litres.
■
Attach the cover and turn anti-clockwise
all the way into the blender handle. The
cover must be locked in position.
■
Set the rotary switch to the desired
setting.
Adding more ingredients
Figure
J
-8:
■
Switch off the appliance with the rotary
switch.
■
Remove the lid and add ingredients.
or
■
remove the funnel and gradually add
solid ingredients through the refill
opening.
or
