9
en
Operating the appliance
Thoroughly clean the mincer before using
for the first time, see “Cleaning and care”.
Important information
In these instructions for use the recom-
mended reference values for the operating
speed refer to appliances with a 7-setting
rotary switch. For appliances with a
4-setting rotary switch you can find the
values in brackets after the values for a
7-setting rotary switch.
■
Assemble mincer attachment in the
indicated sequence
(Fig.
A
)
. Do not
fully tighten threaded ring.
■
Insert seal. Note position
(Fig.
C
)
!
Figure
D
:
■
Press the Release button and
move the swivel arm to
position
4
.
■
Connect mincer to the drive.
Note position of the driver (1d) with
respect to the drive.
If required,
turn the driver slightly. To do this, the
threaded ring must not be screwed
tightly!
■
Turn mincer anti-clockwise.
■
Press down locking lever.
■
Now tighten the threaded ring.
■
Attach filler tray.
■
Place a bowl or plate under the outlet
opening.
■
Insert the mains plug.
■
Set rotary knob to setting 7 (4).
■
Place the food to be processed in the
filling tray.
■
Use the pusher to push in ingredients.
W
Warning!
do not process bones.
Tip:
Process steak tartare through the
mincer twice.
After using the appliance
■
Switch off the appliance with the rotary
switch.
■
Lift up locking lever.
■
Rotate the mincer in a clockwise direc-
tion and remove.
■
Clean mincer.
Cleaning and servicing
Attention!
Do not use abrasive cleaning agents.
Surfaces may be damaged.
Mincer and individual parts are not
dishwasher-proof.
■
Loosen threaded ring and disassemble
attachment.
■
Rinse individual parts by hand and dry
immediately.
Optional accessories
(available from dealers)
W
Warning!
Always assemble the accessories without
blades and perforated discs. Follow all
instructions mentioned above concerning
“For your safety”, “After work” or “Cleaning
and Servicing”.
Fruit press attachment
for pressing e.g. berries, tomatoes, apples,
pears, rosehips (cook rosehips for 1 hour
before pressing). Extracted fruit pulp is
especially suitable for making jam.
Figure
E
:
■
Preparation as described for mincer
attachment. Note required individual
parts and sequence when assembling
the fruit press attachment.
■
First undo the fastening screw as far as
is required to allow the pulp to flow out
while still moist.
■
Then adjust the fastening screw until
the pulp flows out with the required
moisture.
■
Place the food to be processed in the
filling tray. Use the pusher to push in
ingredients.
■
Set rotary knob to setting 7 (4).
