Bosch MIC-7502-Z30B, Installation Manual, Page: 41 / 47

MIC IP starlight 7000i Appendices | en 41
Bosch Security Systems Installation Manual 2017.09 | 0.12 | F.01U.xxx.xxx
Status
Code Description Recommended action
(to be completed by a qualified Service
Technician)
10 Camera is detecting high humidity
level inside housing. The integrity of
the housing seal may be
compromised. 1. Inspect the window for any cracks or
obvious damage around the edge of the
window.
2. Verify the integrity/tightness of the
external fasteners. Tighten where necessary.
3. Verify the integrity of the mechanical seals
around the tilt head, pan body, and arm
joints.
4. If damage to the seals is obvious, contact
the nearest Bosch Security Systems Service
Center.
5. If no obvious damage is found, power the
camera off and then on. If the status code
reappears, contact the nearest Bosch
Security Systems Service Center.
11 Wiper operation has been halted
because of an obstruction. 1. Remove any obvious materials that are
obstructing operation of the wiper.
2. If the obstruction is from ice buildup,
review the diagnostic log of the camera
(accessible from the
Service menu) for errors
related to operation of the internal heaters
(and the window defrosters, for MIC IP fusion
9000i). If possible, tilt the camera so that the
front faceplate is pointed straight up. (In this
position, heat generated by the camera will
help to melt ice buildup from its front
faceplate area.)
3. If the obstruction is from extreme ice
buildup, temporarily avoid operating the
wiper until internal heaters, combined with a
rise in ambient temperature, melt the ice
buildup.
12 Left and Right Pan Limits have been
set too close to each other. Re-configure one camera stop limit or the
other to increase the distance between limit
stops to at least 10° apart.
13** Autofocus has been turned off
because of excessive focus activity. 1. If practical, increase lighting in the scene
so that the focus function stops “hunting.”
2. Use focus in manual mode or One-Push
mode.
14** Washer operation was attempted
without washer pre-position being
stored. Configure the washer pre-position. If
necessary, refer to the subchapter “Using the
Wiper/Washer (Bosch AUX/Pre-position
Commands)” in the User Manual for details
on configuring washer functions.