Robert Bosch LLC
M-VCI – NETGEAR® Router Installation Guide Index | Version 1.0 | April 2011
11
| Installation Steps |
Step 4
Note:
The S/N shown should agree
with the S/N on the label of the
M-VCI unit.
Step 4 – Setting up your
M-VCI (Applies to Types I,
II & III) (Clearing Existing
Network Settings)
f
Click: Network Setup Tab
f
Click: Clear Network Settings
f
Click: OK
f
Wait for the “Configuration
Complete” Message
Step 4 – Setting up your
M-VCI (Applies to Types I,
II & III) (Configuring Wired
Ethernet Settings)
While in Network Setup:
f
Click: Wired Ethernet Tab
f
Click: Enable Wired Ethernet
Interface
Note:
If your network utilizes
Static IP addresses, do not enable
Wired Interface with Static IP.
Note:
This will allow M-VCI to
be connected to any network
Ethernet port if there is limited or
no wireless coverage.
Step 4 – Setting up your
M-VCI (Applies to Types I, II
& III) (Configuring Wireless
Connection Settings)
While in Network Setup:
f
Click: Wireless (802.11) tab
f
Click: Enable Wireless Interface
f
Click: Access Point button
Summary of Contents for Mastertech M-VCI
Page 1: ...Mastertech M VCI NETGEAR Router Installation Guide ...
Page 2: ......
