Installation | 3
Bosch Motorsport
Telemetry_System_LTE65_Manual
7 / 28
3 Installation
Mount the LTE65 transmitter device in the vehicle in a place that will remain relatively dry
and away from direct heat sources. The receiver device should be placed on the pit stand
in free air.
Tapped mounting holes are provided on the LTE65 transmitter device if you wish to hard-
mount the device in your vehicle. Please see the offer drawing in Appendix A for hole
thread size, depth, and placement.
Metal, carbon fiber panels, and heated windscreens negatively affect antenna perform-
ance.
3.1 Power Supply and Voltage
Min. Supply Voltage
8 V DC
Max. Supply Voltage
18 V DC
24 V operation possible on agreement
with customer
Internal Power Backup
30+ seconds
Power Consumption
6 W
3.2 Car Specific Antennas
3.2.1 GT Car
The GT car antenna available from Bosch Motorsport is a dual 4G MIMO antenna with 3G
fallback, both MIMO antennas are in the same housing.
Recommended torque spec for the antenna connection: 4 in-lbs (0.45 Nm)
Suggested installation locations shown in in the figure below.
Preferred Locations:
Secondary Locations:
Summary of Contents for LTE65
Page 1: ...Telemetry System LTE65 Manual Version 1 2 26 08 2020 ...
Page 23: ...Drawings 7 Bosch Motorsport Telemetry_System_LTE65_Manual 23 28 7 2 Pit Stand Harness Drawing ...
Page 27: ...Bosch Motorsport Telemetry_System_LTE65_Manual 27 28 ...
Page 28: ...Bosch Engineering GmbH Motorsport Robert Bosch Allee 1 74232 Abstatt www bosch motorsport com ...
