Bosch Junkers TR 100, Manual

Page: 15 / 92

TR 100
15
English
The respective red control light (l) is off.
The standard heating mode set at the time
switch is ignored.
The economical operating mode will be active
until
• midnight (00.00 hours)
or
• the button (h) is depressed again;
the regulator is set back to automatic oper-
ating mode
or
• the button (g) is depressed;
the regulator is set to continuous operating
mode.
In all cases the respective yellow control
light (i) will turn off and the regulator will regu-
late the temperature to the set values.
Use this mode if you exceptionally
leave your house (e.g. for shopping) and the
house should not be heated for this time. As
soon as you are back depress the button (h)
again, the regulator is operating in automatic
mode again and will heat according to the set
temperature.
If you leave the house in the evening or if
you would like to go to bed early depress the
button
(h). The regulator terminates the eco-
nomical heating mode at midnight and will
switch back to the usual automatic operating
mode the next morning.
6.2 The “2
nd
operating range”
The “2
nd
operating range” is accessible after
opening the lid.
6.2.1Control knob
“economic temperature” (m)
With this control knob (m) the temperature
to which the regulator must regulate in the
automatic operating mode when set to
“economic”, as well as in "economical
operation mode" (h).
6.2.2 General information on the timer
The time switch makes it possible to automat-
ically switch the heating system on once a day
at a pre-set time, and switch it off automatical-
ly once a day at a pre-set time. Those set
times are valid for all days.
Setting the time ( )
The display (e) shows the time (at initial oper-
ation or power failure over a longer period the
time pre-set by the factory):
The regulator is automatically set to the pro-
gramming mode when the lid is opened. Set
the control knob (n) to “
” .
The time is set by depressing the buttons “-”
(o) or “+” (p) .
Briefly depressing the button alters the time by
1 minute, when the button is depressed for a
longer period the time runs faster forward or
backward. The seconds are set back to “0”. As
soon as the button is released the clock will
operate normally.
If no buttons are depressed the clock also op-
erates normally.
The time before 12.00 hrs. (12
noon)can be set faster with the “-” (o) button.
When no more alterations are necessary
close the lid.
Setting the starting time for
heating (
)
The regulator is automatically set to the pro-
gramming mode when the lid is opened. Set
the control knob (n)
to the position (start
heating).
The display (e) shows the pre-set starting time
(at initial operation or power failure over a
longer period the starting time pre-set by the
factory):
The required starting time is set by depressing
the buttons
“-” (o) or “+” (p) .
☞
Tip
10
20
25
30
15°C
5
☞
Tip