!
Caution!
Ensure that the pole mount installation is secure and stable. Failure to do so may result in
personal injury, or damage the device.
Wall mount installation
Installing the transmitter and receiver:
1.
Remove the cover and mounting plate from the transmitter.
2.
Route the wire through the mounting plate wire entry if the wire is routed through a wall
opening. If the wire is routed on the wall surface, knock-out the thin wall wire hole at the
bottom of the transmitter and cover. Route the wire through the opening after the
mounting plate is secured onto the wall.
3.
Secure the mounting plate to the wall surface.
4.
Route the wire through the detector wire entry location.
5.
Secure the transmitter to the mounting plate.
6.
Wire to the terminal strips. Refer to Wiring for wiring procedures.
7.
Repeat this procedure for mounting the receiver.
1
4
2
6
5
3
Figure 3.5: Wall mount installation
Callout
ー
Description
Callout
ー
Description
1
ー
Mounting screws
4
ー
Device securing screws
2
ー
Mounting plate
5
ー
Knockout
3
ー
Detector
6
ー
Wire entry
3.3
12
en | Installation
Photobeam 5000
2016.02 | 03 | F.01U.305.910
Installation and Operation Guide
Bosch Security Systems, Inc.
