Bosch Integra SHX46L02UC, Use And Care Manual

Page: 11 / 44

9
d) Look for obstruction in the spray
nozzles.
e) If the spray nozzles need cleaning,
flush them under running water.
- To reinstall the top spray arm:
f) Return the top spray arm to its
installed position.
g) Return the locking nut to its
installed position and turn it 1/8 turn
clockwise.
h) Return the top rack to the top rack
roller guides.
- To remove the bottom spray arm:
i) Remove the empty bottom rack from
the dishwasher tub.
j) Grasp and lift the bottom spray arm
as shown in Figure 23.
k) Look for obstruction in the spray
nozzles.
l) If the spray nozzles need cleaning,
flush them under running water.
- To reinstall the bottom spray arm:
m) Return the bottom spray arm to its
installed position and press it so that it
snaps into place.
n) Return the bottom rack to its
installed position.
5. Check/Clean the Filter System
Your Bosch dishwashers has a filter
system that is made up of a Large Object
Trap/Cylinder Filter assembly, a Fine
Filter, and a Micro Filter. The filter system
is located on the dishwasher floor and is
easily accessible.
During normal use the filter system is
self-cleaning, but you should
occasionally inspect it for foreign objects
and clean it when necessary.
Figure 23
INJURY HAZARD:
The large object
trap could contain sharp objects. Do
not reach into the large object trap
with your fingers.
C A U T I O N
- To Remove the Large Object
Trap/Cylinder Filter Assembly:
a) Remove the bottom rack.
b) Grasp the assembly as shown in
Figure 24, and turn it counterclockwise
1/4 turn.
c) Lift out the assembly as shown in
Figure 25.
Figure 25
Figure 24
d) Carefully examine the assembly. If
you find debris in the Large Object
Trap, turn it upside-down and gently tap
it on a surface such as a countertop to
dislodge and remove the debris. Flush
the Cylinder Filter clean by holding it
under running water.
- To Remove the Fine Filter and
the Micro Filter:
e) Lift the Fine Filter from the
dishwasher floor as shown in Figure
26 and flush it clean by holding it under
running water.
If your dishwasher will be unused for
an extended period of time in a location
that experiences freezing temperatures
(e.g., in a holiday home or through a
vacation period), you must drain all the
water from the dishwasher’s interior.
a) Turn off the water supply.
b) Disconnect the drain hose, and
allow your dishwasher to completely
drain into a bucket or other appropriate
receptacle.
1. Wiping Up Spills and Splash-out
Water may occasionally splash out of
your Bosch dishwasher, especially if you
interrupt a cycle or open the dishwasher
door during a cycle. To avoid floor
damage and possible mold growth, do
not allow wet areas to remain around or
under the dishwasher.
3. Check/Clean the Stainless Steel
Inner Door and Tub
a) Clean the outer edges of the inside
door panel regularly to remove debris
that might collect there from normal
loading.
b) If spots begin to appear on the
stainless steel tub or inner door, make
sure the rinse agent reservoir is full.
4. Check/Clean the Spray Arm
Nozzles
Occasionally check the spray arms to
ensure that the spray nozzles are
unobstructed. You must remove the
spray arms to check them for obstruction.
- To remove the top spray arm:
a) Remove the empty top rack from the
dishwasher.
b) Turn the rack upside-down. The top
spray arm is held in position by a locking
nut as shown in Figure 21A. Turn the
locking nut counterclockwise 1/8 turn and
remove it, as shown in Figure 21B to
release the spray arm.
Figure 22
Figure 26
c) Remove the spray arm as shown in
Figure 22.
CARE AND MAINTENANCE
Figure 21
A
B