English 8
OPERATING MODES
You can use this appliance in the air extraction or the
recirculation mode.
NOTE:
All openings in ceiling and wall where the hood will
be installed must be sealed.
Fan operation
The air that is drawn in is cleaned by
the grease
fi
lters and exhausted outdoors
by a ductwork.
NOTE:
Ventilation may not exit through an already
operational smoke or exhaust chimney, nor a duct used
for ventilating furnace installation areas.
•
If the ventilation is intended to pass through a
smoke or exhaust chimney that is not in operation,
the responsible area heating inspector must give
approval.
•
If the ventilation passes through an external wall, use
a telescopic wall sleeve.
Recirculating mode
The air that is drawn in is cleaned by the
grease
fi
lters and activated carbon
fi
lters
and returned back into the kitchen.
WARNING
Improper installation of gas appliances and ventilation hoods
can create a risk for carbon monoxide which can be harmful.
To reduce the risk of carbon monoxide poisoning, ensure
the gas appliance is properly installed according to the
manufacturer’s instructions, as well as ensuring the hood is
vented to the outside for proper exhausting of gases or fumes.
Refer to local building codes for latest requirements and
restrictions when installing ventilation products in recirculation mode.
Recirculating mode
fi
lters
To bind odors in recirculating mode, charcoal
fi
lters must be
installed. The required charcoal
fi
lter kits are available for
purchase from specialist retailers, from customer service or
from the Online Shop. See table below to
fi
nd out the
fi
lter
kit part number corresponding to the unit model.
Unit Model
Charcoal Filter Kit
HUI34253UC
HUIFIL46UC
HUI36253UC
HUI86553UC
HUI30253UC
HUIFILT0UC
HUI80553UC
Installing recirculating mode
fi
lters
1. Remove the grease
fi
lters from the hood. Install a charcoal
fi
lter (included in the charcoal
fi
lter kit) on each metal
grease
fi
lter back (
A
). Hold the charcoal
fi
lter in place by
inserting both ends of 2 metal strips (included in the
charcoal
fi
lter kit) in each metal grease
fi
lter frame slot (
B
).
2. Reinstall the grease
fi
lters by simultaneously using your
other hand to grasp under the metal grease
fi
lter, then
fl
ip
metal grease
fi
lter up and snap the latch into place.
UNIT OVERVIEW
Refer to the illustration at right to identify the parts of your
appliance:
A
: Filters
B
: LED modules
C
: Touch control panel.
A
B
B
C
B
A
Slot
