The cooker must also be installed in accor-
dance with local regulations. Failure to
install the cooker correctly could invalidate
the warranty liability claims and could lead
to prosecution.
Gas Connection
Prior to installation, ensure that the local
distribution conditions (nature of the gas
and gas pressure) and the adjustment con-
ditions are compatible. The adjustment
conditions for this appliance are stated on
the rating plate which can be found on the
back cover. This appliance is not designed
to be connected to a combustion products
evacuation device. Particular attention
should be given to the relevant require-
ments regarding ventilation.
Connection to the cooker should be made
with connection in accordance with local
regulations (see also table 2 on page 43).
• In order to guarantee that the cooker
works safely and has a moderate energy
consumption and long service life, you
must ensure that the supply pressure cor-
responds to the values given in table 1. If
this is not the case, a special pressure
regulator must be fitted to the gas supply
pipe in accordance with the relevant stan-
dards.
• The cooker must be connected to the gas
supply pipe such that the cooker is not
subjected to any kind of stress.
A special valve for routinely turning the gas
supply on/off must be installed between the
gas inlet tube to the room end the hob, in
order to cut off the gas supply after cooking
in the event of accidents during cooking.
This valve must be easily accessible at all
times, end should be closed during long
periods of no use.
The gas tube must be routed in such a way
that it is not fed through hot areas and does
not come into contact with any hot parts of
the appliance, e.g. the underside of the hob.
Tube installation must be carried out in
such a way as to ensure that it runs freely
and that it cannot come into contact with or
be bent by any movable parts in the
kitchen, e.g. drawers.
GB
Installation instructions
41
1-2”
