English |
13
Bosch Power Tools
1 609 92A 1VR | (30.11.15)
Inserting Screwdriver Bits into the Bit Magazine (see figure B–C)
When changing the application tool, wear safety goggles. Do not stare direct-
ly into the tool holder.
When changing the tool insert, it can be thrown out toward
the front.
Only insert one screwdriver bit per chamber into the bit magazine. Use only
short standard screwdriver bits.
Longer screwdriver bits cannot be loaded into
the bit magazine.
– Turn the bit magazine
10
until an empty chamber can be seen in viewing window
3
.
– Push the sliding switch
4
toward the front.
– Insert the screwdriver bit
1
directly into the tool holder
2
.
– Push the sliding switch
4
to the rear to load the screwdriver bit
1
into bit magazine
10
.
– As soon as you push the sliding switch
4
to the rear or actuate the On/Off switch
9
when in the rear position, the bit magazine
10
is illuminated for approx. 20 sec-
onds.
Changing the Tool (see figure D)
When changing the application tool, wear safety goggles. Do not stare direct-
ly into the tool holder.
When changing the tool insert, it can be thrown out toward
the front.
– Turn the bit magazine
10
until the desired screwdriver bit
1
can be seen in viewing
window
3
.
– Push the sliding switch
4
toward the front.
Operation
Starting Operation
Reversing the rotational direction (see figure E)
The rotational direction switch
7
is used to reverse the rotational direction of the ma-
chine. However, this is not possible with the On/Off switch
9
actuated.
OBJ_BUCH-2023-003.book Page 13 Monday, November 30, 2015 2:45 PM
