INSERTINg/REPlACINg THE BATTERy
Use only alkali-manganese batteries.
To open the battery lid 14, press the latch
15 in the direction of the arrow and fold up
the battery lid. Insert the supplied battery.
Pay attention that the polarity is correct,
according to the + and - symbols on the
inside of the battery lid.
The battery indicator h always indicates the
current battery status:
- Battery fully charged
- Battery has 2/3 of its capacity or less
- Battery has 1/3 of its capacity or less
- Please change battery
• If the tool is not used for a long period of
time, the battery must be removed. The
battery can corrode or discharge itself over
long periods.
INITIAl OPERATION
• Protect the tool against moisture and
direct sunlight.
• Do not expose the tool to extreme
temperatures or variations in temperature.
In case of large variations in temperature,
allow the measuring tool to adjust to the
ambient temperature before switching it
on. Extreme and variations in temperature
can impair the display and accuracy of the
tool.
• Use operation of transmitting systems,
such as WlAN, UmTS, radar, transmitter
masts or microwaves, in the close
proximity can influence the measuring
function.
RECOmmENDATIONS FOR
PROPER SCANNINg
Avoid wearing jewelry such as rings or
watches when using the detector. The metal
may cause inaccurate detection.
• Move the detector uniformly the surface
without lifting it off or changing the applied
pressure.
Preparation
-6-
Wall Scanner gmS 120
Article number
3 601 K81 010
Maximum scanning depth*:
Ferrous metals
4-3/4” / 121 mm
Non-ferrous metals (copper)
3-1/8” / 80 mm
Live wires 110V / 230V (voltage applied)*
2” / 50 mm
Wood substructures (studs)
1-1/2” / 38 mm
Automatic switch-off
After approx. 5 min
Operating temperature
14 °F ~ 122 °F
(–10 °C ~ +50 °C)
Storage temperature
– 4 °F ~ +158 °F
(–20 °C ~ +70 °C)
Battery
1 x (9V) (6LR61)
Operating lifetime (alkali-manganese batteries)
Approx. 5 h
Weight according to EPTA-Procedure 01/2003
0.60 lbs / 0.27 kg
* Depends on material and size of objects as well as material and condition of structure.
** Less scanning depth for wires/conductors that are not “live”.
Please observe the article number on the type plate of your detector.
Technical Data
Operation
