9
Assembly
button/coin cell battery is swallowed or
enters the body, it can cause severe
internal burns and can lead to death in
as little as 2 hours. Always completely
secure the battery compartment. If the
battery compartment does not close
s e c u r e l y , s t o p u s i n g t h e p r o d u c t ,
remove the batteries, and keep it away
from children. If you think batteries
might have been swallowed or placed
i n s i d e a n y p a r t o f t h e b o d y , s e e k
immediate medical attention.
Operating Instructions
▶ Protection Against Deep
Discharging
The lithium ion battery is protected
a g a i n s t d e e p d i s c h a r g i n g b y t h e
“ E l e c t r o n i c C e l l P r o t e c t i o n ( E C P ) ” .
When the battery is empty, the cordless
area light is switched off by means of a
protective circuit.
▶ Turning the Area Light On
To turn the area light ON, press the
O n / O f f b u t t o n
2
. T o i n c r e a s e t h e
brightness, press the On/Off button a
second time. To turn area light OFF,
press the On/Off switch a third time
(Fig. 1).
▶ Temperature Dependent
Overload Protection
In order to protect both the user as well
as the area light, the area light switches
off if the heat sink temperature reaches
140°F (60°C). Allow the cordless area
light to cool down, then switch the
cordless area light on again.
Do not continue to
p r e s s t h e O n / O f f
switch after the cordless area light has
been automatically switched off.
The
battery can be damaged.
▶ Low Battery Warning
Shortly before the cordless area light
switches off because of a low battery, it
w i l l f l a s h 3 t i m e s a n d s h i n e w i t h
reduced brightness.
▶ Adjusting the Brightness
Pressing the On/Off button
2
will turn
on the area light to the low brightness
setting. Pressing the button again will
turn the area light to the high brightness
setting.
▶ Run Time
The run time will depend on the Bosch
b a t t e r y
p a c k
c a p a c i t y
a n d
t h e
brightness setting of the area light. The
run time on the high brightness setting
will be 80 minutes per Ah of the battery
pack.
▶ Fastening to the tripod
You can use the tripod mount to screw
the cordless area light onto a tripod.
Tighten the 1/4" screw. Ensure that the
tripod has a firm footing.
2610051843_GLI18V-1200C 10/1/18 10:24 AM Page 9
