Bosch GlassVAC, Original Instructions Manual

Page: 11 / 165

English | 11
Action Figure Page
Detaching the microfiber cloth
110 mm
Cleaning the microfiber cloth
L 165
Accessories M 165
Initial Operation
Note: The battery is supplied partially charged. To ensure
capacity of the battery, completely charge the battery using
the battery charger before using your machine for the first
time.
The lithium-ion battery can be charged at any time without
reducing its service life. Interrupting the charging procedure
does not damage the battery.
The battery is protected against deep discharging.
When the battery is discharged, the machine will stop.
Battery Charging (see figures A and C)
Note : The micro-USB port (18) for connection of the micro-
USB cable (16) is in the handle.
When the battery charge is low, the charger level indicator
(4) flashes green.
When the charger level indicator (4) flashes red, the battery
must be charged. Turn the machine off and charge the bat-
tery.
Connect the machine to the charger
(17) using the micro-
USB cable (16) provided. Plug the battery charger (17) into
the socket. The charging process begins.
During the charging procedure, the handle of the machine
warms up. This is normal.
The charger level indicator
(4) continuously lights up red
during the charging procedure. When the battery is fully
charged, the charger level indicator
(4) continuously lights
up green .
Disconnect the battery charger from the mains supply when
charging process ends.
Observe the notes for disposal.
Troubleshooting
Problem Possible Cause Corrective Action
Machine will not switch
on Battery discharged Recharge battery
Battery too hot/cold Allow to cool/warm
Restricted or no va-
cuum Suction head blocked Unblock suction head
Drain plug removed Replace drain plug
Machine turns itself off Battery too hot/cold Allow to cool/warm
Suction head blocked Unblock suction head
Water leaks from ma-
chine Spray applicator not mounted correctly Mount the spray applicator correctly
Battery will not charge Battery charger not connected correctly Check battery charger and USB cable connec-
tions
Battery too hot/cold Allow to cool/warm
Streaking on windows Wiper blade damaged Replace wiper blade (accessory)
Too much force applied Apply reduced force
Too little force applied Apply more force
Maintenance and Cleaning (see
figures J–K)
Always clean the product thoroughly after use.
Remove the suction head from the main body and rinse.
Whilst suction head
(2) is removed from the machine, fill the
dirty water tank (7) via the suction head aperture to the max
line with clean, warm water. DO NOT fill the dirty water tank
(7) via the drain hole. Shake the machine and pour the water
out via the drain plug (8) .
Maintenance of the suction head
Protect the suction head against damage during storage.
Prevent the wiper blade from touching paper or cardboard,
as this could damage the wiper blades polymer coating.
Spots or lines may be visible on the polymer coating. This is
normal and does not affect the cleaning performance.
Textiles
Microfiber cloths: 67% polyester, 14% polyamide, 19%
polypropylene
Bosch Power Tools F 016 L81 778 | (20.05.2020)