English |
15
Bosch Power Tools
1 609 929 W90 | (25.10.10)
f
Never use the machine with a damaged ca-
ble. Do not touch the damaged cable and
pull the mains plug when the cable is dam-
aged while working.
Damaged cables in-
crease the risk of an electric shock.
f
Products sold in
GB only
: Your product is fit-
ted with an BS 1363/A approved electric
plug with internal fuse (ASTA approved to
BS 1362).
If the plug is not suitable for your socket out-
lets, it should be cut off and an appropriate
plug fitted in its place by an authorised cus-
tomer service agent. The replacement plug
should have the same fuse rating as the orig-
inal plug.
The severed plug must be disposed of to
avoid a possible shock hazard and should
never be inserted into a mains socket else-
where.
Functional Description
While reading the operating instructions, unfold
the graphics page for the machine and leave it
open.
Intended Use
The power tool is intended for the forming and
welding of plastic, removal of paint and the
warming of heat-shrinkable tubing. It is also
suitable for soldering and tinning, loosening of
adhesive joints and the defrosting of water
lines.
Product Features
The numbering of the product features refers to
the illustration of the machine on the graphics
page.
1
Standing surface
2
Cover with coarse-debris filter
3
On/Off switch with stage selector
4
Nozzle
5
Heat protection collar
6
Program-selection button
7
Display
8
Button for air-flow control
9
Button for temperature control
10
Save button
11
Wide jet nozzle*
12
Glass protection nozzle*
13
Reflector nozzle*
14
Welding rod*
15
Welding shoe*
16
Reduction nozzle*
17
Heat-shrinkable sleeve*
18
Angle nozzle*
*Accessories shown or described are not part of the
standard delivery scope of the product. A complete
overview of accessories can be found in our acces-
sories program.
Noise Information
Measured sound values determined according
to EN 60745.
Typically the A-weighted sound pressure level of
the product is lower than 70 dB(A).
OBJ_BUCH-485-004.book Page 15 Monday, October 25, 2010 3:08 PM
