Bosch FlexiDome2X VDN-498V03, Installation Manual

Page: 17 / 58

FlexiDome2X Installation | en 19
Bosch Security Systems Installation Manual AR18-08-B010 | v1.0 | 2009.03
3.3.3 Surface mounting
When using the surface mounting box:
– With a side connection, remove the cap covering the side
entrance.
With a rear connection, leave the cap in place.
– Attach the conduit to the mounting box.
– Release the two clips at the bottom of the watertight
connection compartment to remove it from the mounting
box.
– Open the cover of the watertight compartment in the
mounting box by releasing the five clips.
– Run the power and video cables through separate rubber
grommets into the watertight compartment.
– Run the cable from the camera into the watertight
compartment through the supplied grommet.
– Make the connection inside the watertight compartment
and clip on the cover to seal it.
Figure 3.5 Surface mounting box VDA-455SMB
Note:
To ensure a watertight cable entry, use round cables of
between 5 and 6 mm (0.2 - 0.24 inches) for power and video
connection.
Note:
Use some silicon spray on the cable to help slide the grommets
onto it.