1 689 979 672
2012-06-26
|
Robert Bosch GmbH
�4 | EPS 807 / 815 | Initial start-up
en
4. Initial start-up
!
The EPS 807 / 815 is only to be assembled, connect-
ed and commissioned by specialist personnel.
4.1
Transportation, installation
Danger: Risk of injury from inexpert han-
dling of the EPS 807 / 815
Bei unsachgemäßem Transport von Inexpert
handling of the EPS 807 / 815 could lead to
injuries resulting from falling or tipping-up of
the unit.
¶
Wear safety shoes.
¶
Always use suitable transportation and
lifting equipment with an adequate load-
bearing capacity.
¶
Observe the center of gravity (refer to
center of gravity symbol).
¶
Always secure at the specified lashing
points when moving with a crane and lift-
ing equipment.
¶
Never stand beneath suspended loads.
BOSCH
B2
A1
A2
A3
A1
B
A
458735/9W
n
B1
A Crane (hoisting gear)
A1 Round steel bars
A2 Base support on the cables with paint protection
A3 Rotate into a favourable transportation position
B With fork lift truck
B1 Symbol for centre of gravity
B2 Place board (1000 x 700 x 25 mm) under the test bench to pro-
vide forks with a level support surface
Install the test bench on a solid and level floor using the
enclosed felt pads and align with a spirit level. The up-
per edge of the oil pan is the reference point.
4.2
Removing transportation safeguards
1.
By removing the upper covers (on the left and right)
and the 4 bolts with the red spacer sleeves (1).
1
458735/10
2.
Open the switch cabinet door and remove the fastening
screw (1) with the transportation lock marked red.
4
5
458735-23
1
2
