Bosch e103022, Installation Instructions Manual

Page: 9 / 64

IMPORTANT!
Before you begin, you must read the safety instructions.
PRE-INSTALL CHECKLIST
� Unpack unit. Retain packing material until successful installation is
complete.
� Remove all packing material from inside the dishwasher.
� Inspect parts to ensure you have all the necessary materials.
� Flush household hot water supply for at least two minutes.
� Measure the enclosure area.
� Is the opening at least 34" (863.6 mm) high and 24" (609.6 mm) wide?
� Is the opening near enough to the sink for the water line and drain
hoses to access plumbing?
� Will the unit be installed close enough to the sink so that drain hose
length does not exceed 92" (2336.8 mm) and so that a portion of the
drain hose is raised at least 20" (508 mm) above the floor?
� Do the openings for electric cable, water line, and drain hose routing
through cabinet fit within the shaded area in Figure 1?
� Are the openings sanded smooth if wood or covered by a protective
gasket if metal?
� Is your water heater set at 120°F (49°C) and does water pressure
measure 15-145 psi (1-10 bar)?
� If installing in a corner, will the dishwasher door clear cabinet
hardware?
� Determine mounting method based on dishwasher model and
countertop type (see Figures 6-8, 20).
� Only use included hardware for install. If replacing dishwasher,
dispose of old hose and other equipment properly.
7