Operating the appliance
en
9
Sensor control
In automatic mode, the PerfectAir sensor in the
extractor hood detects the intensity of the cooking and
roasting odours. Depending on the setting of the
PerfectAir sensor, the fan automatically switches itself to
another fan setting.
Possible sensor settings:
Default sensitivity setting:
„
(fan setting 3)
Lowest sensitivity setting:
‚
(fan setting 1)
Highest sensitivity setting:
†
(fan setting
D
)
If the sensor controller responds too strongly or not
enough, it can be changed accordingly:
1.
Touch and hold the
>
symbol when the fan is
switched off. The setting will be displayed.
2.
The sensor controller setting can be changed by
touching symbols 1, 2, 3,
C
or
D
.
3.
Take your finger off the
>
symbol.
Saturation display
If the metal grease filters or activated charcoal filter are/
is saturated, the corresponding symbols will flash once
the appliance has been switched off:
■
Metal grease filter:
E
■
Activated charcoal filter:
F
■
Metal grease filter and activated charcoal filter:
E
and
F
If you have not yet done so, the metal grease filters
should now be cleaned or the activated charcoal filter
"Cleaning and maintenance" on page 13
The saturation indicators can be reset while they are
flashing. To do this, touch the appropriate symbol.
Switching over the display for air recirculation mode
For air recirculation mode, the electronic controller must
be switched over accordingly:
■
The extractor hood must be connected and switched
off.
■
Touch and hold the
D
symbol. Touch the "2"
symbol.Take your finger off the
D
symbol. This
will switch the electronic controller over to air
recirculation mode (filters that cannot be
regenerated).
■
Touch and hold the
D
symbol. Touch the "3"
symbol.Take your finger off the
D
symbol. This
will switch the electronic controller over to air
recirculation mode (filters that can be regenerated).
■
Repeatedly touching and holding the
D
symbol
and touching the "1" symbol switches the electronic
controller back over to air extraction mode.
Decorative LED lighting
The decorative LED lighting can be switched on and off
independently of the fan.
Touch the
l
symbol.
Setting the brightness
Press and hold the
l
symbol until the required
brightness is reached.
Setting the colour
1.
Switch off the fan.
2.
Touch the
l
symbol.
3.
Touch the 1 or 2 symbol until the colour you require
is selected.
Lighting
The lighting can be switched on and off independently
of the fan.
Touch the
B
symbol.
Setting the brightness
Press and hold the
B
symbol until the required
brightness is reached.
Audible signal
Switching on
Touch and hold the
#
and
y
symbols at the same
time for approximately 3 seconds when the fan is
switched off. An audible signal will sound as an
acknowledgement.
Switching off
Touch and hold the
#
and
y
symbols at the same
time for approximately 3 seconds when the fan is
switched off. An audible signal will sound as an
acknowledgement.
