EN
| 17
Bosch Security Systems | 20 January 2004
DVAS
|
Instruction Manual
|
Before You Begin
Check the check box and click
Quickstart configure for
(x)
DVR
.
Figure 10 Quick Config Confirmation
Quick Config
adjusts the settings required to configure
the disk array to work with 1 or 2 DVRs. If prompted
for a system reboot, manually cycle the power
switches. Once the system reboots,
Quick Config
has
finished.
6.5
Setting Up SCSI Interfaces
The DVAS Series disk array’s SCSI settings are
preconfigured to work with Bosch DVRs, without any
adjustments.
To accommodate future products, the SCSI settings
may be altered. This section explains each setting.
To change the SCSI setting select
System
on the
DVAS Series disk array’s main page.
Select the
SCSI
tab to access the SCSI settings.
When the
Configure SCSI
page is loaded in the main
frame, use the drop down menus to select the new
setting for the SCSI host channels.
SCSI ID
Use the drop down menu to choose the desired ID.
Termination
AUTOMATIC
is the default setting and will work with
all Bosch DVRs.
SCSI Max Transfer Rate
Defines the maximum speed of the SCSI bus. The
default setting for the DVAS is
Ultra2
. This setting
should only be changed if the DVR specifies a
different setting.
Click
Save Settings
to save these settings.
Power cycle the unit so the new Network and SCSI
settings are applied.
Figure 11 SCSI Interfacing
Figure 12 SCSI Settings