DS6R2
|
Installation and Operation Guide | 3.0 Programming
.
Bosch Security Systems, Inc. | 4/08 | F01U081960-01
9
3.0
Programming
Use the Master Code for programming. The three User Codes cannot be used to program the
DS6R2.
The default Master Code is
1234
. If you forget the Master Code, reset the DS6R2 to its default
values. Refer to
Section 3.5 Resetting Default Values
on page 14.
3.1
Entering Programming Mode
1.
Enter the Master Code.
2.
Press and hold the [*] key for 3 sec.
The keypad beeps and the zone LEDs flash quickly to indicate that you entered Programming Mode.
3.2
Changing Programming Values
3.
Enter the programming address (
x
or
xx
), then press [*].
Program Addresses
0
through
9
require only one digit.
Program Addresses 10
through
99
require two digits.
4.
Enter the desired value.
The programming value can be from one digit to nine digits in length, depending on the address. A beep
indicates the input is accepted. Refer to
Table 3
on page 10.
5.
Repeat
Steps 3
and
4
to program other addresses.
If you make an incorrect entry before completing the number, press [*] to clear the previous entry,
and then re-enter it.
If you enter the wrong digits and complete the number, press [*] and re-enter the program address
number and the program value.
Example 1:
To change the Master Code (Program Address 0) to
3345
, enter the address, press [*],
then enter the desired value: [0]+[*]+[3]+[3]+[4]+[5].
Example 2:
To enable the Quick Arm function (Program Address 28): [2]+[8]+[*]+[1].
3.3
Exiting Programming Mode
Press and hold
[*]
for 3 sec to exit Programming Mode. The keypad beeps and the zone LEDs turn off, indicating
you have exited Programming Mode.
