24
en
Connection in Ducting Version
When installing the ducting version, connect the
hood to the chimney using either a fl exible or rigid
pipe ø 150 or 120 mm, the choice of which is left to
the installer.
To install a ø 120 mm air exhaust connection,
insert the reducer fl ange 9 on the hood body
outlet.
Installation
9
ø 120
ø 150
Fix the pipe in position using suffi cient pipe
clamps (not supplied).
Remove charcoal fi lters, if present.
Connection in Recycling Version
All the items named in this procedure are
included in the recycling kit. The corresponding
accessory numbers can be found at the end of
these operating instructions.
Put connection 15 into the connection support
7.3.
Insert the connection extension pieces laterally
14.1 in connection 15.
Make sure that the outlet of the extension
pieces 14.1 is horizontally and vertically aligned
with the chimney outlets.
Connect the air outlet connection 15 to the
hood body outlet using either a pipe ø 150 mm.
Chimney assembly
Upper Chimney
Slightly widen the two sides of the upper Chim-
ney and hook them behind the brackets 7.2.1,
making sure that they are well seated.
Secure the sides to the brackets using the 4
screws 12c supplied.
Make sure that the outlet of the extensions
pieces is aligned with the chimney outlets.
Ensure that the activated charcoal fi lters have
been inserted.
Lower Chimney
Slightly widen the two sides of the Chimney
and hook them between the upper Chimney
and the wall, making sure that they are well
seated.
Fix the lower part laterally to the hood body us-
ing the 2 screws 12c supplied.
7.3
25
ø 150
14.1
15
7.2.1
12c
2
2.1
2.2
12c
12c
