D1255RB/D1256RB/D1257RB | Installation Guide | 3.0 Installation
6
Bosch Security Systems B.V. | 2020.03 | F01U011791-02
502 Kpuvcnncvkqp
3.1 Mounting Information (D1255RB,
D1256RB, and D1257RB)
The D1255RB, D1256RB, and D1257RB are low-
profile, surface-mounted units molded in
durable red plastic. Use the D56 Keypad
Conduit Box (protected surface or flush mount)
for mounting the units.
Mounting Locations
•
Do not mount the keypads and
annunciators in locations where
they are exposed to direct sunlight.
Direct sunlight can interfere with
the display screen’s visibility and
damage internal components.
•
Do not mount the units in wet or
moist locations.
3.2 Wiring Information (D1255RB,
D1256RB, and D1257RB)
A four-wire flying lead is required for the data
and power connections between the keypad or
annunciator and the control panel. The unit
includes a wiring harness with four color-coded
flying leads at one end and a female four-pin
connector at the other end.
Refer to
Figure 10
and
Figure 11
on page 9 to
wire the D1255RB, D1256RB, or D1257RB.
3.3 Installation Procedure
1.
Power down the control panel.
2.
Using a small flat-bladed screwdriver, gently
push the two bottom tabs up and in to
release the enclosure base. Refer to
Figure 2
.
Use caution to avoid damage to the
tabs and hinges.
Figure 2: Releasing the Enclosure Base
1 - Screwdriver
2 - Tabs
3 - Enclosure base
3.
Gently lift the unit from the enclosure base
as the tabs are pushed in.
Figure 3: Lifting the Keypad from the
Enclosure Base
1 - Enclosure base
2 - Tabs
4.
Gently pull the keypad apart from the
enclosure base at the top hinges.
