Bosch CCS 900 Ultro, Installation And Operating Manual

Page: 28 / 46

28 en | Built-in MP3 recorder (CCS-CURD only) CCS 900 Ultro
IOM_CCS900 | V1.0 | 2010.06 Installation and Operating Manual Bosch Security Systems B.V.
7.3.3 Setting the date and time
Figure 7.4 Set-up screen for date
Before using the MP3 recorder you should make sure that the date and time are correctly set.
If necessary, adjust the date and time as follows:Refer to Figure 7.1
1. Press the change mode button (1) to select the set-up mode. When selected, the set-up
icon should be shown in the top right-hand corner of the display (see following figure).
2. Press the select button (2) to change the date settings.
3. Press the up or down button (4 or 5) to change the value (year number), and then press
the next button (3) to select the next value to change.
4. Set the date (year, month, and day) as described in the previous step, and then press the
select button (2) to jump to the time set-up screen.
5. Set the time (hours, minutes, and seconds), using the same method as described in step
3, and then press the select button to jump to the bit rate set-up screen (see following
section).
7.3.4 Selecting the bit rate
1. Press the up or down button to change the value (bit rate). The following bit rates are
available:
– 64 kbps
– 96 kbps
– 128 kbps
– 192 kbps
– 256 kbps
2. Press the select button to select the next value to change (see following section).
NOTICE!
To change settings in the set-up mode, you must follow the programmed sequence of events
(there is no back button). To exit the set-up mode at any time, press the change mode button
(button 1 at the left-side of the display).