RE 95240-01-B/2021-01-12, Bosch Rexroth AG
Safety instructions |
BODAS controller RC/3x and RC/4x
9
/24
• Do not use defective components or components which are configured incorrectly.
Failed or incorrectly operating components must be repaired immediately.
• Control units used to develop software must not be installed in series production
machines as the number of flash cycles is limited and may have been reached or
exceeded.
2.6 Product-specific safety instructions
The following safety instructions apply to chapters 6 to 14.
WARNING
System/machine under pressure!
Risk of death or serious injury when working on unsecured machines/systems!
Property damage!
▶ Switch off the relevant machine/system part and secure it against reactivation
according to the parameters by the machine/system manufacturer.
CAUTION
Improper cable and line routing!
Risk of stumbling and property damage! Improper routing of cables and lines
can cause a risk of stumbling as well as damage to equipment and components,
e.g. due to lines and connectors being torn off.
▶ Always install cables and lines in a way that nobody can fall over them, that
they are not bend or twisted, do not chafe on edges and are not guided through
ducts with sharp edges without sufficient protection.
Danger due to malfunctions!
Risk of injury and property damage as well as machine damage due to malfunctions
of the sensor!
▶ Carry out a risk assessment of your machine and determine the possible
safety-relevant functions.
▶ Take suitable measures to ensure safety in applications relevant to safety,
e.g. sensor redundancy, plausibility check, emergency switch, etc.
▶ Product data that is required for the safety assessment of the machine is
included in data sheets 95204, 95205, 95206, 95207 and 95208.
2.7 Personal protective equipment
The personal protective equipment is the responsibility of the user of the product.
Observe the safety regulations in your country.
All pieces of personal protective equipment should be intact.
