Indoor Pendant & In-ceiling Models |
Instruction Manual
|
Installation
Bosch Security Systems | 10 December 2003
EN
| 12
3
TRIM RING REPLACEMENT
The Camera Module ships with an optional trim ring.
If the trim ring currently installed on the camera
module does not match the color of your pendant or
ceiling décor, simply replace it with the one provided
by following these steps.
1. With a slotted screwdriver, carefully pry each of the
six (6) trim ring tabs away from the camera
module, as shown in PHOTO 11. Take extra care
not to allow the dome surface to come in contact
with anything that could scratch it.
Photo 11: Pry Tabs away from Camera Module
2. Position the new trim ring so that the hole aligns
with the locking screw, as shown in PHOTO 12.
Photo 12: Position Trim Ring
3. Using a slotted screwdriver, carefully pry the trim
ring tabs while pressing on the trim ring at the
same time. It may help to use the edge of a table
while doing this, but again, be sure not to allow the
dome surface to come in contact with anything that
might scratch it. Secure all six (6) tabs, as shown in
PHOTO 13.
Photo 13: Secure Trim Ring
Tabs
Tabs
Hole
Locking
Screw
