Bosch AUTODOME IP starlight 5100i, User Manual

Page: 42 / 80

42 en | Camera AUTODOME IP starlight 5100i
2020-11 | draft 0.9 |
User Manual
Bosch Security Systems
Select Off to hide azimuth/elevation readings.
Proportional speed
Select On to increase Proportional speed.
Select Off to decrease Proportional speed.
Proportional speed mode
Options are Super Slow, Slow, Medium, and Fast.
Maximum pan speed [%]
Select the maximum pan speed (in percent). Settings range from 1 to 100. The default is 100.
Maximum tilt speed [%]
Select the maximum tilt speed (in percent). Settings range from 1 to 100. The default is 100.
Auto pan left limit
Sets the left Auto Pan limit of the camera. Use the preview window to move the camera to the
left pan limit and click the button. The camera will not move past this limit when in Auto Pan
Between Limits mode (AUX 2 ON).
Auto pan right limit
Sets the right Auto Pan limit of the camera. Use the preview window to move the camera to
the right pan limit and click the button. The camera will not move past this limit when in Auto
Pan Between Limits mode (AUX 2 ON).
Tilt up limit
Sets the upper tilt limit of the camera. Use the preview window to move the camera to the tilt
limit and click the button.
Tour A / Tour B
Starts and stops the recording of a recorded (guard) tour.
The camera can make up to two (2) recorded tours. A recorded tour saves all manual camera
movements made during the recording, including its rate of pan, tilt and zoom speeds, and
other lens setting changes. The tour does not capture camera video during the recording of
the tour.
Note 1 : You can save a total of 15 minutes of recorded actions between the two tours.
To record a tour:
1.
Click the Start Recording button. The system prompts you to overwrite the existing tour.
2. Click Yes to overwrite the existing tour movements.
3. Click the View Control link, under the image cameo, to access the directional and zoom
controls.
4. Use the View Control dialog box to make the necessary camera movements.
5. Click the Stop Recording button to save all actions.
Note : Tour B is now intended for use with the 'IVA while moving' functions.
You must first calibrate the camera to North before the camera displays accurate compass
headings. The camera uses this calibration, usually set to magnetic North, as the zero degree
pan position and as the North compass heading. The camera then displays the compass
heading based on the number of degrees from the North calibration point.
To set the North calibration point:
1.
Determine the North compass heading, then move the camera to that position.
2. Select the radio button On for the parameter Compass .
3. Click the button next to North point to set the calibration point.
North point
– Click the Set button to overwrite the existing North point . A dialog box appears with the
message, “Overwrite North point ?” To confirm, click OK . To cancel, click Cancel .