Bosch Ascenta SHE5AM02UC, Use And Care Manual

Page: 10 / 64

10
x SHE5AM
x
x
Rinse Agent Dispenser
open the rinse agent dispenser by lifting the tab with your thumb.
NOTE: the dishwasher indicates low rinse agent either by showing the symbol in the
countdown display, or illuminating the refill rinse agent light (model dependent).
add liquid rinse agent to the dispenser as shown in figure 16 until the rinse agent reservoir
is full. Wipe up any excess rinse agent that puddles when the dispenser reservoir is full.
NOTE : After filling the rinse agent dispenser, the indicator light will go out in a few minutes
after the dishwasher door is shut (select models only).
Wash Cycles (See Cycle Chart)
always make sure your dishware is dishwasher safe. refer to the Dishware Materials
section of this manual for guidance.
Power Scrub Plus
Cleans items having baked-on or hard dried-on food soils. these items may require
soaking or hand scouring.
Auto Wash (select models)
Cleans large loads with loosely attached food soils.
Regular
thoroughly cleans large loads having loosely attached normal soiling.
Delicate/Economy (select models)
for delicate or heirloom dishwasher and silverware or other special items. always make sure
that the items are dishwasher safe. refer to the Materials section of this manual for further
information. Hand washing may be the best treatment of such items.
Quick Wash
for lightly soiled items with easy to remove food soils.
Rinse and Hold
allows you to rinse the food soil off of a partial load and hold them in the dishwasher until
there is a full load.
Dishware Drying
at the end of the cycle the dishwasher will stop and a period of condensation drying will
follow.
WARNING
You could be seriously scalded if you allow hot water to splash out of the dishwasher.
OPEN THE DOOR CAREFULLY during any wash or rinse cycle. Do not fully open the door
until water noises have stopped.
Delecat
e / Econo
Rinse and Hold
R
egular
A
ut
omatic
Po
w
er Scrub Plus
Quic
k W
ash
Wash Cycles
x
x
x
x
x SHX3AM
SHE4AM02
x
x
x x x x
SHE4AM12
x
x
OPERATING THE SHX3AM
To start unit:
- Door must be open. Press the “ON/OFF” button to turn the unit on.
- Wash cycle LED will be flashing to indicate pre-select mode.
- press or to select desired wash cycle. Press the START button (Wash Cycle LED will stop flashing).
- Close the door to start cycle
NOTE: Rinse Agent LED will be illuminated if unit needs rinse agent.