AMC2 4W | Installation manual
Safety Instructions | en
13
Bosch Sicherheitssysteme GmbH
F.01U.024.965 | V 0.1 | 2006.03
2.3
Safety Precautions
Read instructions!
Before working with the AMC2 4W, read these instructions
carefully. Make sure you have understood all information
described in this document.
Warning! Risk of electric shock!
External power supplies must be installed and put into service
by qualified personnel. Compliance with the relevant regula-
tions must be ensured.
Warning! Risk of damaging equipment!
•
Always switch off power of the AMC2 4W before mod-
ifying the installation.
•
Do not connect or disconnect plug connectors, data
cables or screw connectors while power is on!
Health and Safety
Installation of the AMC2 4W must comply with any local fire,
health and safety regulations. A secured door that may be part
of an escape route from an area must be installed with:
•
A fail-safe lock (A). So that the door will be released if
power fails. Ideally, a magnetic lock should be used as
these are less likely to jam or seize.
•
A normally-closed break-glass or manual pull (B) in the
lock supply wiring, so that in an emergency the fail-
safe lock can be immediately powered down.