18
| English
F 016 L81 133 | (6.11.14)
Bosch Power Tools
During the charging procedure, the three green LEDs light up
one after the other and briefly go out. The battery is fully
charged when the three green LEDs light up continuously. The
three LEDs go out again approx. 5 minutes after the battery
has been fully charged.
Temperature Control Indicator
The red LED signals that the battery or the electronics of the
garden product (with battery inserted) are not within the op-
timum temperature range. When this occurs the garden prod-
uct will not operate or not at full capacity.
Temperature Control of the Battery
The red LED flashes when you press the button or the On/Off
switch (with battery inserted): The battery is outside of the
permitted operating temperature range.
The battery switches off at a temperature above 70 °C until
the optimum temperature range is reached again.
Battery Maintenance
Use the following procedures to enable optimum usage of the
battery:
– Protect the battery against moisture and water.
– Store the battery only within a temperature range between
–20 °C and 50 °C. As an example, do not leave the battery
in the car in summer.
– Do not leave the battery in the product in direct sunlight.
– The ideal storage condition for the battery is 5 °C.
– Occasionally clean the venting slots of the battery using a
soft, clean and dry brush.
A significantly reduced working period after charging indi-
cates that the battery is used and must be replaced.
Troubleshooting
Problem
Possible Cause
Corrective Action
Hedgecutter does not operate
Battery discharged
Recharge battery; also see “Battery
Charging”
Battery not fully connected
Ensure both locking levels are engaged
Hedgecutter operates intermittently
Internal wiring of machine damaged
Contact Service Agent
On/Off switch defective
Contact Service Agent
Motor reverses repeatedly then stalls af-
ter 3 s.
see “Working Advice” (Anti Blocking)
Motor runs but blades remain stationary Internal fault
Contact Service Agent
Cutting blade hot
Cutting blade blunt
Have blade sharpened
Cutting blade has dents
Have blade inspected/overhauled
Too much friction, due to lack of lubricant Apply lubricant spray
Blade will not move
Battery discharged
Recharge battery; also see “Battery
Charging”
Machine defective
Contact Service Agent
Excessive vibrations/noise
Machine defective
Contact Service Agent
Cutting time per battery charge too low
Too much friction, due to lack of lubricant Apply lubricant spray
Blade needs cleaning
Clean blade
Poor cutting technique
see “Working Advice” (see Fig. 5)
Battery not fully charged
Recharge battery; also see “Battery
Charging”
The blades are running slow or the anti
blocking feature is not functioning
Battery discharged
Recharge battery; also see “Battery
Charging”
Battery stored outside of battery temper-
ature
Allow battery to warm naturally to room
temperature (within battery operating
temperature 0 – 45 °C)
OBJ_BUCH-948-005.book Page 18 Thursday, November 6, 2014 1:10 PM
