4
WARNING!
Please read all assembly, and maintenance instructions
carefully before beginning set-up of the components in
this document.
Where appropriate, warning symbols have been
included in this publication to alert you of potential or
impending danger.
•
Be sure to read and observe all safety warnings in
this document as well as those attached to the
individual modules. Failure to do so could result in
potential risks to your health and safety as well as
those around you.
•
Covers and guards have been designed to
eliminate pinch points and exposure to moving
components.
DO NOT
operate the adjustable
height workstation or any machinery with the
guards removed. Serious injury may result!
•
All set-up maintenance and repair work should
be performed only by properly trained, qualified
personnel. All operators must be properly trained
in the use of this equipment.
• Be sure to follow all local, state and federal
regulations when installing electrical devices of
any type
•
Unplug the workstation before beginning
maintenance or repair work of any type on the
adjustable height workstation.
•
The adjustable height workstation is designed to be
used in assembly operations where ergonomic
considerations dictate the need for a height
adjustable workstation. Table top maximum width is
1400 mm. The minimum width is 1000 mm.
It will accommodate extension arms for tool
holders, balancers, lights, parts bins and power
strips. Maximum workstation load must not exceed
400 lb (181.5 kg), either centered or distributed.
Exceeding published specifications will result in
premature wear, damage, or failure of the motor,
gearbox, seals and/or other components.
•
CAUTION–Tip over hazard!
Extension arms with
tool holders and parts bins can present a potential
tip over hazard under certain height and load
conditions. Table tops with overhangs also present
a potential for tip over. Be sure the load is always
centered on the table top. If it is not possible to
center the load, be sure it is evenly distributed
from side to side and front to back. DO NOT sit,
stand or lean on table tops! DO NOT exceed the
maximum allowable moment of 500 Nm as shown
in the diagram below! For maximum stability and
safety Bosch Rexroth recommends anchoring the
workstation to the floor. A number of floor
anchoring options can be found in the Bosch
aluminium structural framing catalog available
through your local distributor.
SAVE THESE INSTRUCTIONS!
IMPORTANT SAFETY INFORMATION
Allowable Moment=
500 Nm Maximum