Bort 91276018, User Manual

Page: 8 / 27

7
tool long can cause a voltage drop and cause the mo-
tor to overheat. Leave to cool down. Use heavy duty
extension cables.
5. The pump does not reach the necessary pressure.
● Water inlet, filter is clogged
- Clean the water inlet filter
● Pump sucking air from connections or hoses
- Check that all supply connections are tight
● Suction/ delivery valves are clogged or worn out.
- Check that the water feedinghose is not leaking
● Unloadervalve is stuck
- Clear or respire valves
● Lance nozzle incorrect or worn out
- Loosen and re-tighten regulation screw.
Check and/ or replace.
PRODUCT FEATURES:
WATER SUCKING FUNCTION.
The Machine could connect to water supply tap, or suck
water from a bucket.
Take the suck hose out of bucket, hold the Nozzle on Low
pressure Postion at first.
Keep the machine running a few seconds to draw-out
surplus water and air in the machine.
Put hose back to water, hold the Nozzle on Low pres-
sure Postion.
Switch it to High pressure Position after water flow a lot
from Nozzle.
5. SERVICE & MAINTENANCE
WARNING! Unplug the electric cable (power
source) prior to any maintenance or prepara-
tory storage operations.
Make sure that the machine is not live when carrying out
maintenance work on the motor.
● To ensure good performance, check and clean the
suction and detergent filters after every 50 hours of
operation.
● Long periods of disuse may lead to the formation of
lime scale deposits. Working through the hole on the
rear, RELEASE the motor using a screwdriver (for
models with this feature).
Then remove the screwdriver and proceed with the
restart operations.
CLEANING
Keep the ventilation slots of the machine clean to prevent
overheating of the engine. Clean the housing regularly
with a soft cloth, preferably every time it is used. Keep
the air vents free from dust and dirt. Remove stubborn
dirt with a soft rag moistened in soapy water. Do not use
any solvents such as petrol, alcohol, ammonia, etc. as
such substances can damage the plastic parts.
LUBRICATION
The appliance does not need any extra lubrication.
STORAGE AND TRANSPORTATION
Keep the high pressure washer in well-ventilated dry
premises with temperature not going below +5ºC. Oper-
ate the cleaner with non-corrosive/non-toxic antifreeze
before storing for the winter.
FAULTS
If a fault arises through wear in an element, please con-
tact the service address shown on the warranty card. A
drawing of the spare parts that may be obtained is in-
cluded at the end of these operating instructions.
ENVIRONMENT
To prevent damage during transport, the appliance is
delivered in a solid packaging which consists largely of
reusable material.Therefore please make use of options
for recycling the packaging.
Autogoods “130”
130.com.ua