www.BormannTools.com
prevent the raising of the tool
’
s head during the tooling. Hold the tool firmly with
both handles.
2)
Respect the cutting directions according to figure
3)
Making circular shapes
Mount the parallel guide ; and adjust the centring point on the guide. Lock the
tightening buttons
4)
Chamfering
To chamfer the outlines of curved lines use the guide on which is set the finishing
guide with a knob
5)
Milling parallel
Use the guide for parallel milling. The graduated ruler allows obtaining the desired
distance
6)
Grooving with a gauge
USE THE GUIDE (8) AND MILL SLOWLY CHECKING THE EFFICIENT EVACUATION
OF SAWDUST. CONSIDER THE 21MM OF THE GUIDE AND THE DIAMETER OF THE
CIRCULAR CUTTER BLOCK FOR THE MAKING OF YOUR GROOVE.
7)
Cutting speed:
THE SPEED REGULATOR (1) ALLOWS ADAPTING THE CUTTING SPEED TO THE
MATERIAL TOOLED AND TO THE TYPE OF THE CIRCULAR CUTTER BLOCK USED.
TESTING ALLOWS A BETTER SELECTION
Ⅵ
. Maintenance:
- Unplug from the mains to perform maintenance
- Keep the tool clean: the cleaning of plastic parts is done with a soft damp cloth and
a bit of mild soap. Never submerge the tool and do not use detergents, alcohol, spirit,
etc.
…
- Keep ventilation holes clear. Avoid having sawdust enter in the tool
- The replacement of carbons and the repair of the tool
’
s inner components
should only be carried out by qualified persons.
Ⅶ
. Environment:
Preserve the environment and bring this tool, at the end of its service life, in a
recuperation and recycling centre for electrical appliances (according to regulations
and geographical location).
Summary of Contents for BRT1200
