BorMann 035947, Manual, Page: 8 / 43

EN
WWW.BORMANNTOOLS.COM
8
4. Release trigger. Turn the PRIME/SPRAY knob to PRIME.
Turn the pump OFF (O). Trigger the gun into the waste con -
tainer to be sure that no pressure is left in the hose.
5. Lock the spray gun off. Make sure the saddle and black seal are in
place inside the tip guard nut. Thread the spray tip guard assembly
onto the gun. Tighten by hand.
Begin tightening the tip at this angle
To achieve the desired spray angle when
tight
NOTE - Be sure that the paint hose is free of kinks and clear of objects with sharp cutting edges.
1. Switch the pump ON (l). Turn the PRIME/SPRAY knob to
SPRAY. Turn the pressure control dial to maximum pressure (+).
The spray hose should stiffen as paint begins to flow through it.
2. When motor shuts off, unlock the spray gun and spray a test
area to check the spray pattern.
The motor will cycle on and off automatically as it needs pres -
sure.
The pressure control dial can be be adjusted up or down to
achieve the desired spray pattern.
Good spray pattern
Paint tailing pattern (pressure too low, clogged tip)